Catalog HONEYWELL

INTERLOCK: M436A1116 SPRING RETURN MOTORS BY HONEYWELL ARE FOR TWO-POSITION BACK DRAFT, OUTDOOR AIR CHANGEOVER, ZONE, OR MINIMUM POSITION DAMPER CONTROL.

INTERMITTENT PILOT CONTROL: S8610U3009 BY HONEYWELL IS A ONE OR TWO ROD INTERMITTENT PILOT CONTROL WITH CONTINUOUS RETRY TRIAL TIME WITH CONFIGURABLE LOCKOUT TIMING OF 15 OR 90 SECONDS AND CONFIGURABLE PREPURGE OF 30 SECONDS OR NO PREPURGE.

LINE VOLTAGE THERMOSTAT: T6051A1016 HEAVY DUTY LINE VOLTAGE THERMOSTATS BY HONEYWELL ARE USED TO CONTROL FAN COILS, FANS, MOTOR STARTERS, VALVES, CONTACTORS, AND CIRCULATOR MOTORS IN HEATING AND/OR COOLING SYSTEMS. • PROVIDE GOOD LINE VOLTAGE COMFORT CONTROL. • USE WITH Q651A,B SUBBASES FOR SYSTEM AND FAN SWITCHING. • REMOVABLE SETPOINT KNOB LOCKS SETPOINT AND PREVENTS TAMPERING. • WITH LOCKING COVER.

MANUAL POTENTIOMETER: S963B1128 MANUAL POTENTIOMETER FOR SERIES 90 SYSTEMS. OUTLET BOX MOUNT, OPEN/CLOSE SCALE, 135 OHM.S963B1128 POTENTIOMETER BY HONEYWELL IS FOR CHECKOUT OF W973 LOGIC PANELS AND W975 SATELLITE SEQUENCERS. • SIMULATES HEAT AND COOL RAMP SIGNAL OF A T7067 DUAL SET POINT THERMOSTAT AND ECONOMIZER LOW LIMIT FUNCTION. • CONSISTS OF 2 POTENTIOMETERS AND A RESISTOR ASSEMBLY MOUNTED IN A TEST BOX. • PROVIDES A HEAT/COOL RAMP SIGNAL FROM LESS THAN 2 VDC (MIN) TO 16.6 VDC (MAX). • S963B1128 ALSO PROVIDES AN ECONOMIZER LOW LIMIT SIGNAL FROM 4.0 VDC (EQUIVALENT TO 45 F (7 C) AT C7046 DISCHARGE SENSOR) TO 4.5 VDC (EQUIVALENT TO 69 F (21 C). • FOUR TEST LEADWIRES HAVE COLOR-CODED BANDS WITH CORRESPONDING W973 TERMINAL NUMBERS. • LEADWIRES HAVE ALLIGATOR CLIPS FOR EASY CONNECTION TO W973 TERMINALS.

MANUAL RESET: HOMEYWELL C6097A1012 PRESSURE LIMIT SWITCH FOR AIR, NATURAL OR LP GAS, LOCKOUT OR PRESSURE FALL, FLANGE MOUNT MODELS CONNECT DIRECTLY TO V5097 OR V4297 VALVESNPT MOUNT, 3-21" W.C., WITH MANUAL RESET

MOTORIZED ZONE VALVE: V8043E1004 TRADELINE. 1/2" SWEAT LOW VOLTAGE MOTORIZED ZONE VALVE. TWO-WAY ON-OFF LOW VOLTAGE VALVES BY HONEYWELL CONSIST OF AN ACTUATOR AND VALVE ASSEMBLY FOR CONTROLLING FLOW OF HOT WATER. MANUAL OPENER (ON ALL MODELS, EXCEPT STRAIGHT-THROUGH, NORMALLY OPEN VALVES) FOR VALVE OPERATION ON POWER FAILURE; VALVE RETURNS TO AUTOMATIC POSITION WHEN POWER IS RESTORED.

MOTORIZED ZONE VALVE: V8043E1020 1" SWEAT 24V LOW VOLTAGE TWO-WAY ON-OFF MOTORIZED ZONE VALVE BY HONEYWELL CONSIST OF AN ACTUATOR AND VALVE ASSEMBLY FOR CONTROLLING FLOW OF HOT WATER. MANUAL OPENER (ON ALL MODELS, EXCEPT STRAIGHT-THROUGH, NORMALLY OPEN VALVES) FOR VALVE OPERATION ON POWER FAILURE; VALVE RETURNS TO AUTOMATIC POSITION WHEN POWER IS RESTORED.

MOUNT: L4006H1004 130-270F TEMP RANGE STOP SET AT 250F WITH STRAP ON MOUNTING. WELL. STRAP ON MOUNTING.

MOUNT: LP920A1013 WELL MOUNTING TYPE WITH 3/8 X 5-1/4 BULB AND 3 CAPILLARY.

MOUNTING ADAPTER: L4064B2236 BY HONEYWELL FOR CONTROL OF HIGH LIMIT AND FAN MOTOR IN ALL TYPES OF FORCED AIR HEATING SYSTEMS.

MOUNTING SHIELD: 107323A MOUNTING SHIELD W/HONEYWELL MONOGRAM FOR USE W/T6031 /W7000 + OTHER TEMP CON- TROLS TO COVER BULB AT END OF CAPILLARY FROM EXPOSURE TO SUN.

OIL BURNER CONTROL: R8184G4009 OIL BURNER CONTROL BY HONEYWELL PROVIDES AUTOMATIC, NONRECYCLING CONTROL OF AN INTERMITTENT IGNITION OIL BURNER SYSTEM.

PNEUMATIC THERMOSTAT: TP9600A1007 DIRECT ACTING THERMOSTAT, W/SETPOINT & THERMOMETER VISIBLE & ADJUSTABLE.TP9600A1007 PNEUMATIC THERMOSTAT IS FOR PROPORTIONAL CONTROL OF PNEUMATIC VALVES AND ACTUATORS WITH ONE- OR TWO-PIPE SYSTEMS. AVAILABLE WITH TWO COVER OPTIONS, TP9600 IS NOT ONLY AFFORDABLE AND EASY TO INSTALL, BUT IT CONTROLS TEMPERATURE WITH RELIABILITY THAT ONLY HONEYWELL CAN PROVIDE.

POSITION INDICATOR: MN7220A2007 DIRECT-COUPLED DAMPER ACTUATORS BY HONEYWELL PROVIDE ADJUSTABLE MODULATING CONTROL FOR: AIR DAMPERS, VAV UNITS, AIR HANDLING UNITS, VENTILATION FLAPS, LOUVERS, AND RELIABLE CONTROL FOR AIR DAMPER APPLICATIONS WITH UP TO 4.6 M2/50 SQ FT (SEAL-LESS DAMPERS; AIR FRICTION-DEPENDENT).

PRIMARY CONTROL: RA117A1047 BURNER CONTROL BY HONEYWELL IS A ONE-PIECE, STACK-MOUNTED OIL BURNER PRIMARY CONTROL THAT CYCLES BURNER ON AND SHUT DOWN BURNER ON FLAME LOSS OR SYSTEM MALFUNCTION.

SAIL SWITCH: S688A1007 SAIL SWITCH BY HONEYWELL ACTIVATES AN ELECTRONIC AIR CLEANER, A HUMIDIFIER, OR OTHER EQUIPMENT IN RESPONSE TO AIRFLOW FROM SYSTEM FAN. S688A IS MOUNTED IN RETURN AIR DUCT WHERE SAIL WILL BE IN DIRECT PATH OF AN UNRESTRICTED AIR STREAM.

SCREW TERMINAL: Q7230A1005 INTERFACE MODULE BY HONEYWELL IS FOR CONVERTING SERIES 90 MODUTROL IV MOTORS TO SERIES 70 (ELECTRONIC) CONTROL.

SENSING ELEMENT: H46E1013 BY HONEYWELL PROVIDES AUTOMATIC CONTROL OF A HUMIDIFIER OR DEHUMIDIFIER FOR DEHUMIDIFICATION IN AIR CONDITIONING SYSTEMS. • POSITIVE ON-OFF SETTINGS PERMIT MANUAL OPERATION OF CONTROLLED EQUIPMENT.

SENSING ELEMENT: L4081A1023 HIGH LIMIT, LOW LIMIT AND/OR CIRCULATOR CONTROLLERS BY HONEYWELL ARE USED TO REGULATE BOILER WATER TEMPERATURE IN GAS OR OIL-FIRED HYDRONIC HEATING SYSTEMS.

SWITCH: AP5027-30 AIRSWITCH PRODUCT - HONEYWELL